Cylinder Bushing +8 mm for Sphere Suspension Systems

The Dal Soggio 1P.C06007 Cylinder Bushing +8 mm is an internal suspension component designed for use within compatible Dal Soggio Sphere cartridge systems.

Listed under Sphere Kit Spare Parts and classified as a Bushing, this component is intended to support the correct positioning, spacing, or guidance of the corresponding cylinder or cartridge element within the suspension assembly.

The +8 mm specification identifies the dimensional offset or additional spacing associated with this version of the bushing. It should therefore be used only where the applicable Dal Soggio Sphere configuration specifically requires the +8 mm version.

Because cartridge spacing directly influences internal component position, alignment, and overall suspension geometry, selecting the correct bushing version is important during servicing, rebuilding, or configuration changes.

The 1P.C06007 is intended as a replacement or setup-specific component for professional suspension maintenance.

Key Features

• Genuine Dal Soggio +8 mm cylinder bushing for compatible Sphere suspension systems
• Provides the specified +8 mm spacing for configuration-specific cartridge setups
• Supports correct positioning and alignment of compatible internal suspension components
• Suitable for suspension servicing, rebuilding, and setup-specific component replacement
• Cataloged within the Dal Soggio Sphere Kit Spare Parts and Bushing families

Application & Compatibility

The 1P.C06007 Cylinder Bushing +8 mm is intended for compatible Dal Soggio Sphere suspension systems where this specific +8 mm spacing configuration is required.

Exact compatibility may depend on the Sphere generation, fork platform, cartridge architecture, and internal setup, so the part number should be verified against the applicable Dal Soggio service documentation or exploded diagram before installation.

Function

The cylinder bushing acts as an internal spacing, locating, or guiding component within the cartridge assembly.

The +8 mm version is intended to provide a larger spacing offset than the +4 mm configuration, helping achieve the correct internal component position for the specified suspension setup.

Installation Note

Correct bushing selection is important for cartridge alignment, internal geometry, and proper suspension operation.

Installation should be carried out by a qualified suspension technician or according to the relevant Dal Soggio technical documentation.

Use only where Dal Soggio specifies the +8 mm cylinder bushing configuration.